It causes yellow leaves and twig dieback, as well as sunken discolored areas of tissue. Dogwood Tree Bark is Peeling Due to Diseaseĭogwood anthracnose is a common disease in the Cornus genus. This condition is easily corrected by giving the plant supplemental moisture.
CHEROKEE BRAVE DOGWOOD PAINTING CRACKED
Drought conditions can cause cracked bark near the base. It is a good idea to site them where winter sun won’t be aggressive or paint the trunk with latex paint thinned with water. Sunscald on young trees may also result in peeling bark. None of these conditions are good for the tree but would be categorized as wildlife problems and completely normal in certain regions. Small rodents may also chew on trunks and cause sloughing bark. Other times that peeling bark on dogwoods may be normal is when it occurs due to wild herbivores rubbing their antlers or standing on the trunk. The dogwood bark peeling off is part of this tree’s appeal, along with its winter interest and fall display of purple leaves. It has bark which peels off in irregular patches, revealing a mosaic of mottled colors underneath. The Kousa dogwood is an ornamental tree that is more cold tolerant than flowering dogwood. When a Dogwood with Peeling Bark is Normal For this reason, the tree bark flaking on dogwood trees may be the result of a canker, borer, string trimmer, or fungal disease, to name but a few. They are quite winter hardy but are sensitive to mechanical injury and a variety of pests and diseases. Many of the varieties are deciduous and provide a rich fall color display followed by bright green, yellow, coral, and orange revealed stems. The plants may be trees or shrubs in form, but all of them offer extraordinary color and many of them flower. Knowing the species of your tree is crucial to deciding if a dogwood with peeling bark is in danger or if it is a normal occurrence.ĭogwood is both a native and introduced species across North America, especially the cooler climates. Peeling bark on dogwoods may be the result of serious disease or it could be a natural condition in some species. Most flower and fruit and have dazzling fall displays as the leaves change color. When the cutting starts shooting up new growth, it's ready to be planted outdoors.Dogwoods are native ornamental trees. When the cutting has grown roots, acclimate it by opening the bag for an hour at a time, increasing the intervals until the bag is removed.If not, close up the bag and wait another three weeks. After five weeks, open up the bag and test for roots by gently moving the cutting.The plant should be about 12 inches below the grow light. Place the plant, dome and all, under grow lights for 18 hours each day.Mist the cutting with water before sealing the bag.Make sure the wire dome and the bag over it are at least 1 inch away from the top of the dogwood cutting. Use a planting dome to cover the dogwood cutting.Insert it into the prepared hole in the pot. Make sure the powdered hormone covers the first few inches of the stem. Immediately dip the cutting in water and then in rooting hormone.Using a very sharp blade, cut 1/2 inch up on either side of the cutting, coming up from the cut end.It should be cut 1/2 inch below a leaf node. Cut the stem at a 45-degree angle with very sharp shears. It should have new leaves at the top and be flexible, not the type of wood that snaps or breaks upon bending. Choose a cutting that is healthy and straight.Create a hole in the middle for the cutting. Start with a moist mixture of perlite and peat moss in a 7-inch pot.The Spruce Home Improvement Review Board.